SeeLevel sensor lengths for 2000 m/y coach

September 07, 2024, 05:59:17 pm

I grabbed the following from Bill B's install post since this was also on a 2000

Quote from: Bill B – May 23, 2021, 05:10:21 pm

Used the standard 16 in strips on the black and grey tanks. They were a little short so I mounted them about an inch from the top of the tanks. I could see that the top of the tanks are not perfectly flat. The strips are about 3 inches off the tank bottom. I was more concerned when tank full than when empty. The fresh water tank I used two 12 in strips and cut one section off bottom of each one. Measures from just below the overflow hose to about 2 inches off bottom.

I'm getting ready to order our SeeLevel (709-N2K so we can interface with a Victron Cerbo GX. Yes, we realize this model doesn't have an LP sensor).

Looking at the angle of our black and grey tanks (the wedge base that tilts the tanks 2 inches lower on the output side), we're thinking 2 stacked AR sensors (9" models with 1" increments, cut as needed) each for those tanks, and then the 2 ES2 12" sensors stacked for the fresh tank.

Anyone see an issue with this sensor plan?

Re: SeeLevel sensor lengths for 2000 m/y coach

Reply #1 – September 08, 2024, 10:19:04 am

Sounds like that would work and give you more precise empty / full readings than my install. Good luck!

Foretravel Owners' Forum For owners and Fans of Foretravel Motorcoaches September 08, 2025 ...