Skip to main content ↑ ↓
Topic: trimetric install question (Read 633 times) previous topic - next topic

trimetric install question

Can I remove the shunt/fuse t-TRON JJN 350 AND INSTALL A 50MV 500AMP SHUNT TO CONNECT A TRIMETRIC 2025A. thanks jc 99 320
JC
1999 U320

Re: trimetric install question

Reply #1 –
Short answer: no
1. That fuse for the inverter and you need to keep it.
2. That fuse only feeds the inverter (unless it was hooked up unconventionally) and you wont capture all the other (non-inverter) battery loads on the Trimetric.
When installing the shunt for the Trimetric you need to have all the loads passing through the shunt or your Trimetric wont be accurate.  Most installations have the shunt on the negative side of the battery bank.
John Fitzgerald
1991 U300 (SAI) Side Aisle Island Bed 40'
Detroit 6V92 with Allison Retarder
Meridian (Boise), Idaho

Re: trimetric install question

Reply #2 –
John is right. The TriMetric has to have that shunt because it measures everything as a voltage drop across the (very small resistance) shunt. Mine is installed on the negative side of the house batteries in series; shunt connects to the negative pole of the first house battery and the ground cable connects to the other side of the shunt. It is not a fuse even if it sorta looks like one.

Craig
1993 U225 36' Unihome GV with PACBRAKE exhaust retarder, Banks Stinger and Solar Panels.
Toad: 1999 Jeep Wrangler 2-door soft-top.

"No one has ever had to evacuate a city because the solar panels broke."

Re: trimetric install question

Reply #3 –
There are several good threads with photos of different Trimetric installations and lots of other information over at rv.net. Here's how I did the one in our 99. You can run the wire directly up under your cabinets using an existing hole or just drill another.

On our 95 I used the factory shunt location and wiring and disabled the ammeter above the entry door which was a poor location for that meter.
jor
93 225
95 300
97 270
99 320

Re: trimetric install question

Reply #4 –
that is exactly the same position mine is as I like to see it while travelling down the road. The remote panel for the Morningstar MPPT is on the opposite side of cabinet to this one
John H
Coachless, now use aircraft. 2003 Ford Travelair TC280 class C. Super shape. Just for 1 yr .
1994 Ford E350 ClassC,total renovation inside and out. Now sold.
2000 U295  36' Cummins 350 c/w Banks Stinger, Resonator upgrade,Solar, LED lites.Residential fridge with slide out pantry. Build 5674. Sold
ex 92 GV 022C ored Cummins. Sold
ex 95 GV240 cat 3116. Sold
2017 Mini cooper s & 2016 land Rover LR2 HSE  LUX.
jhaygarth@aol.com    SKP #130098
treat everyone as you would like to be.
 

Re: trimetric install question

Reply #5 –
Thanks to all for your info. I get it now, on to the midnite classic 150 more questions probably on the way. jc 99 320
JC
1999 U320