Skip to main content ↑ ↓
Topic: Generator running rough (Read 475 times) previous topic - next topic

Generator running rough

I ran the generator this morning for about an hour.  I remember it runs no smooth,  but this time I can feel vibrations.  What do would think,  fuel filter,  injectors?  Do I need to take it to a generator specialist?
Tom Lang K6PG (originally  KC6UEC)
and Diane Lang
2003 38 U295 build 6209
2016 Jeep Grand Cherokee Summit Ecodiesel
still have tow-ready 2006 Acura MDX 
Temple City, California
Motorcade 16681 California Chapter President
SKP 16663 member of SKP Park of the Sierra, Coarsegold California
FMCA F071251
Retired electrical and electronic engineer

Re: Generator running rough

Reply #1 –
Tighten the nuts that hold the genset slide tray...works every time.  If that does not work, I suspect air may be getting into the fuel delivery lines.
Peter & Beth Martin
No Forrest? What have you done?
MC# 15890 until Dec 2016; FMCA #F329677
Cincinnati, OH
 

Re: Generator running rough

Reply #2 –
Good suggestions from Peter especially about the nuts. Also check the rubber mounts. Bad on ours. Have to look from the bottom as the damage/wear is not visible from the top. Air in system usually results in a surging and not vibration but not always.

Good to run a diesel injection cleaner occasionally and then run the generator for a while.

Pierce
Pierce and Gaylie Stewart
'93 U300/36 WTBI
Detroit 6V-92TA Jake
1140 watts on the roof
SBFD (ret)