Skip to main content ↑ ↓
Topic: Di=electric grease (Read 568 times) previous topic - next topic

Di=electric grease

Anyone have trouble with the cruise control because of too much Di-electric grease on rear stop light  bulbs?
'02 U295 36'
Build #5937

 SKP#104358
Motorcade#17428

Re: Di=electric grease

Reply #1 –
Most cruise control systems need to see a ground on the hot side of the brake light bulb.  The ground connection is from the bulb's ground, through the bulb's filament.  If something increases the resistance (like maybe grease?), it is possible for it to interfere with cruise control.  Did it work again after cleaning off grease? Ground connection is needed so the cruise knows that when brakes are applied, the bulb will light and the cruise circuit knows it will see 12v positive to turn cruise off.  I all brake bulbs are burned out or missing usually cruise will not engage.

Re: Di=electric grease

Reply #2 –
Check the connections at the brake light switch.  These are located in the 1st driver side compartment at the front wall of the enclosure. This area is susseptible to moisture and rust.
Peter & Beth Martin
No Forrest? What have you done?
MC# 15890 until Dec 2016; FMCA #F329677
Cincinnati, OH

Re: Di=electric grease

Reply #3 –
Barry and Cindy,
I cleaned the contacts on the bulbs and sockets. Cruise still won't engage. 
Thanks
'02 U295 36'
Build #5937

 SKP#104358
Motorcade#17428

Re: Di=electric grease

Reply #4 –
Peter,
Sorry it has taken so long to get back with you. No internet connection.
I can't seem to locate the contacts that you mentioned.
Thanks for your trouble.
'02 U295 36'
Build #5937

 SKP#104358
Motorcade#17428

Re: Di=electric grease

Reply #5 –
These are located in the front bagage compartment below the driver's side.
Peter & Beth Martin
No Forrest? What have you done?
MC# 15890 until Dec 2016; FMCA #F329677
Cincinnati, OH

Re: Di=electric grease

Reply #6 –
Thanks sooo much for the pics, I'll get on it in the AM.
'02 U295 36'
Build #5937

 SKP#104358
Motorcade#17428
 

Re: Di=electric grease

Reply #7 –
Quote from: Barry & Cindy –
Most cruise control systems need to see a ground on the hot side of the brake light bulb.  The ground connection is from the bulb's ground, through the bulb's filament.  If something increases the resistance (like maybe grease?), it is possible for it to interfere with cruise control.  Did it work again after cleaning off grease? Ground connection is needed so the cruise knows that when brakes are applied, the bulb will light and the cruise circuit knows it will see 12v positive to turn cruise off.  I all brake bulbs are burned out or missing usually cruise will not engage.

Talk about a surprise.. this is news to me.  I've been trying to figure out what's keeping my CC from working for longer than awhile.
Would this brake light situation keep the hi-idle from working? 
I've replaced most everything in the CC system and left the tail lights alone because they seem to be doing their job fwiw.. pc

S/W Houston 95" U320C SE/40' 
Build #4778  Cummins M11
Repairs & Covered RV Parking (BAO)
PPL is close..