Skip to main content
Topic: Sluggish Starting (Read 1187 times) previous topic - next topic

Re: Sluggish Starting

Reply #25
Nice crimp pattern. Lots of them on ebay, nice to have at least 4/0 for the largest. The ground and supply cable to the inverter are 4/0 as I had to put lugs on the ends when I changed the inverter.

Pierce
Pierce and Gaylie Stewart
'93 U300/36 WTBI
Detroit 6V-92TA Jake
1140 watts on the roof
SBFD (ret)

Re: Sluggish Starting

Reply #26
We were able to purchase everything we needed to make up the new battery connections.  Our good friend and forum member Red Tractor had the crimping tool and some 3/0 cable we purchased from him.  Everything else was purchased online. We were not trusting the clamp repair with only 3 threads.  While were were at it we installed the Victron 712 Smart Battery Monitor.  Since we were pressed for time we installed the display in the bay by the shunt.  Once we return from our trip we will see about relocating the display.  All is great and we are on the road to Illinois.  Thanks everyone for the great forum support.
John & Carmen
John & Carm Morales

"We travel not to go anywhere, but to just go.  We travel for travel's sake.  Our great desire is to move."

 

Re: Sluggish Starting

Reply #27
Correction, our cables are 3/0 not 4/0.

Pierce
Pierce and Gaylie Stewart
'93 U300/36 WTBI
Detroit 6V-92TA Jake
1140 watts on the roof
SBFD (ret)