Skip to main content
Topic: Heart Interface Overload Light Blinking (Read 1089 times) previous topic - next topic

Heart Interface Overload Light Blinking

When I was doing my monthly "test" everything today, the Heart Interface overload light starting blinking and the interface shut down.

I have read the instruction book but it does not address the symptom with enough detail for me to pin point the problem.

Any suggestions?

Brian

95 U240 Grandvilla
Orlando, FL
Brian
Orlando, FL
'95 U240
Toad: '94 Jeep Wrangler

Re: Heart Interface Overload Light Blinking

Reply #1
Brian

Clean and make sure all battery connections are tight.
Rick and Mary Zika
unit #4609
new full body paint by Foretravel of Texas
1995 U240 2014 jeep
The selected media item is not currently available."Rick and Mary"

Re: Heart Interface Overload Light Blinking

Reply #2
Consider replacement with Xantrex Prosine 2.0.

Re: Heart Interface Overload Light Blinking

Reply #3
Brian I had the same thing happen to my 97 U295, 1 of my house batteries were bad but also I had a circuit board bad in our Heart 2500 Inverter. Here is a link to Heart or Xantrex service reps. Hope this helps...http://www.xantrex.com/web/id/1/asc.asp
Kerrybob
1995 U295
1997 F250 4dr

Re: Heart Interface Overload Light Blinking

Reply #4

New batteries installed by an RV tech a few months ago.  No trouble with the interface over our summer trip.

The manual says to recycle by connecting to shore power.  I tried recycling with the generator...no luck.

I will double check the battery connections next weekend. 

Brian 
Brian
Orlando, FL
'95 U240
Toad: '94 Jeep Wrangler