Skip to main content ↑ ↓
Topic: Wiring (Read 533 times) previous topic - next topic

Wiring

 2002 U320 3610- do any wires go directly to the rear BR from the drivers overhead cab.? If yes, is it possible to use one wire to pull in a couple new ones or a HDMI cable? It would be good if FT had used a wire-way that would allow that.
Peace,
OH
Rick & Deborah Webster
2002 3610 U320 #5964
2014 Jeep Wrangler Sahara JKU- 'Copperhead'
Richland Chambers Lake, East Texas

Re: Wiring

Reply #1 –
You might be able to pull wires down the extrusion at the top of the wall where the ceiling mounts to the walls
previous 1984 35 ft ORED 250 HP 3208 Cat       
previous 1998 40 ft U295 CAI 325 hp Cummins
previous 2003 40 Ft u320 build #6140 450 Cummins M11.                                                         
1999 Mazda Miata
Ron, Nancy, Tipper the cat, Max The dog
1997 U 270 36 ft build number 5174 8.3 Cummins

Re: Wiring

Reply #2 –
On the upper sides of the walls at the roof connect extrusion that is molded into the roof assembly, is a raceway that is used by the factory to route wiring from the front upper cap area to the rear cap area.  If you remove the panels to the rear of the upper front cabinets and TV you can gain access to the front of the left and right raceway.  The factory routed a coax cable in the right side raceway to the bedroom TV.  If you remove the TV you will find a hole holesawed in the extrusion and a coax cable.  With long fish tape you can route your new cable.

Al 
Leisure Travel
Unity (MB)
2009 Smart Car