Foretravel Owners' Forum For owners and Fans of Foretravel Motorcoaches September 12, 2025 ...

Boost switch solenoid operation

September 09, 2013, 04:52:06 pm

My boost switch light stopped working last week and the boost solenoid also seems to not be "clicking".  My question is a sort of chicken or egg in nature, does the power for the solenoid need to go through the switch or does the solenoid light the lamp in the switch.  Is there a fuse involved anywhere in this scenario?
Mike M.
1997 U320

Quote Selected

Re: Boost switch solenoid operation

Reply #1 – September 09, 2013, 06:11:08 pm

Might pull out your wiring diagram, but on older Foretravels, the boost switch gets power from the ignition solenoid.

Brett

Quote Selected

Re: Boost switch solenoid operation

Reply #2 – September 09, 2013, 07:52:18 pm

On my '91 I can activate my boost solenoid with the ignition off and I can hear it clicking. I hit the boost switch periodically when plugged into shore power to keep the chassis battery topped up. My boost light is out too. Doesn't affect operation. The light doesn't get power from the solenoid, it just goes on indicating the switch has been activated.

The boost switch is connected via diodes to both house and chassis batteries so it will operate if either is dead. I suggest temporarily hot wiring your boost solenoid coil terminal (small lug) to either chassis or house battery (either of the large lugs). If you don't hear a click, the solenoid is defective. If you hear a click, then check wiring to the switch, could just be a crusty terminal lug. Try unplugging and plugging back in at the switch, or loosening and re-tightening the small solenoid terminal.

Also, the solenoid ground might have gotten corroded. Try loosening and re-tightening the solenoid mounting screws.

Quote Selected

Re: Boost switch solenoid operation

Reply #3 – September 10, 2013, 09:42:36 am

The bulb in the switch is easily replaceable. Rocker Switch Bulb Replacement

Quote Selected