Skip to main content
Topic: Locking pin slots in front slide. (Read 473 times) previous topic - next topic

Locking pin slots in front slide.

Does anyone know where the water drains from the locking pin slots on the roof top of the front slide?  Or in my case possibly they are draining inside the overhead cabinet and running down to the fabric covered header.
Any thoughts?
'02 U295 36'
Build #5937

 SKP#104358
Motorcade#17428

Re: Locking pin slots in front slide.

Reply #1
Tom when I was at FOT this spring they blew my pin lock drain out. It is outboard center bottom edge of slide. Not much of a hole, so look for it. Get two helpers, have them hold rags over the pin lock holes on top (lots of stuff will come out, I had leaves, gunk ect., this will protect the awing topper). Blow air from the bottom. Good luck...
2002 U270 - sold
2013 New Horizons 5th Wheel - sold
2017 RAM 5500 - sold

Re: Locking pin slots in front slide.

Reply #2
Hi Tom,

In my '02 they drain  at the bottom of the slide almost directly  below the locking pins. The may be blocks with dirt etc, so blow air up the holes in the bottom of the slide. Another consideration is leakage around the drain holes on top the slide where silicone has broken away from the entry holes.

Jim
Jim Frerichs
2002 U320 42'

Re: Locking pin slots in front slide.

Reply #3
Is the drain hole at the outboard end of the slide track that is located at the center of the slide?  Mine is rather rusted there, possibly from the drainage.

Ken
2002 U295 3620

Re: Locking pin slots in front slide.

Reply #4
I checked mine out and that's the only hole I see that could be the drain hole.

Rich
Rich and Peggy Bowman
2002 U270 3610 WTFS, build #5939--"Freedom"
2022 Jeep Grand Cherokee Summit 4xe
SMI AirForceOne brake system
PakCanoe 15