Skip to main content ↑ ↓
Topic: New Pressure Pro sensor valve stem seal (Read 1142 times) previous topic - next topic

New Pressure Pro sensor valve stem seal

Following is from Pressure Pro's announcement of a new sensor seal:

PressurePro's new valve seal solution uses a 2-piece valve seal system. The first piece is a hard plastic depressor that rests on a surface just below the threads. This new plastic depressor has been designed to the optimum length to more fully depress the valve and provides a hard stop during installation, preventing over tightening of the Sensor against the rubber sealing surface; thus preventing damage to the seal. A simple rubber O-ring is pushed into place over the plastic depressor which fits snugly in place and can endure repeated loosening and installation of the Sensor.

Re: New Pressure Pro sensor valve stem seal

Reply #1 –
No mention of cost to retrofit.

Re: New Pressure Pro sensor valve stem seal

Reply #2 –
       It's about time they did something meaningful . Have (not) had good luck with their older thinking and don't give a toot about it .                          Brad Metzger

Re: New Pressure Pro sensor valve stem seal

Reply #3 –
Quote from: Tom Lang –
No mention of cost to retrofit.

If you search online, the cost for 10 seals plus the "tool" (a modified inexpensive hand tool) is $10

PressurePro Tire Pressure Monitor Accessories

I couldn't find anyplace that sold just the seals or where you could buy additional individual seals (for those of us who need 12 for tag axle coach plus toad).