Skip to main content ↑ ↓
Topic: Window screen (Read 606 times) previous topic - next topic

Window screen

One corner of the screen in the bedroom has come loose, so I need to take the screen out to repair it. How does it come out? I had hoped that I could just raise the screen up, slide the bottom out, and the whole thing would be ready to go. Doesn't work that way. Any suggestions?

Re: Window screen

Reply #1 –
 I seem to remember in GVs that those bug screens do not come out without giving them a slight bend in centre. Not much needed so do not force it out.
JohnH
Coachless, now use aircraft. 2003 Ford Travelair TC280 class C. Super shape. Just for 1 yr .
1994 Ford E350 ClassC,total renovation inside and out. Now sold.
2000 U295  36' Cummins 350 c/w Banks Stinger, Resonator upgrade,Solar, LED lites.Residential fridge with slide out pantry. Build 5674. Sold
ex 92 GV 022C ored Cummins. Sold
ex 95 GV240 cat 3116. Sold
2017 Mini cooper s & 2016 land Rover LR2 HSE  LUX.
jhaygarth@aol.com    SKP #130098
treat everyone as you would like to be.

Re: Window screen

Reply #2 –
Don't know how different yours is, but on our '89 there is an insert track on the bottom "sill" track that slides out from under the screen frame towards the front of the coach. Then you are able to lift up on the screen frame and lift it out.

We, if time and location don't permit, clean the screens with Armorall Wipes on both sides. Seems to clean quite well and does not attract dirt/dust.
Nitehawk,  Demolition Lady, & our NEW master, Zippy the speeding BB cat.
1989 Grand Villa 36' ORED
Oshkosh chassis, 8.2 DD V8
2006 Saturn Vue AWD

Re: Window screen

Reply #3 –
Nighthawk is correct.  Use a flat blade screwdriver to carefully pry up the forward end of the lower plastic channel that serves as the bottom slide for the screen.  Pull it out toward the front.

Push up on the screen and clear is from the bottom track and remove.  Replace the screen.  Raise the screen slightly and slide the channel back in from the front.

Sounds more complicated than it is-- takes 30 seconds to remove or replace.
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: Window screen

Reply #4 –
Depending on room you may have to open the window and slide the insert to the outside.  Had to do that on my driver's window insert.  I gave all my windows a good spray with a Teflon spray.  much easier to slide.  Works on the sliding doors and cupboard catches as well.

Keith
Keith, Joyce & Smokey the Australian Cattle Dog
1995 U320 SE Extreme 40' WTBI Build # 4780, with a Honda CR-V hopefully still following behind.
Motorcade # 17030
FMCA # F422159

Re: Window screen

Reply #5 –

For our windows we also use silicone lubricant spray, but we prefer the 8897 dry type from 3M for this task.

Also pays to vacuum the bottom window channel.

Amazing how much easier lubricated windows move.

Amazon.com: 3M 08897 Silicone Lubricant (Dry Type) - 8.5 oz.: Automotive

http://www.nationaltoolwarehouse.com/Silicone-Lubricant-Dry-Type-08897-P2706 .aspx?gclid=CNG60OqGw8ACFahj7AodH2cAVQ

As an Amazon Associate Foretravel Owners' Forum earns from qualifying purchases.

Re: Window screen

Reply #6 –
I followed Barry and Cindy idea after fought too long with windows hard to slide and DW complained.  But in the task I found a tooth brush and some water cleaned out dirt, that alone was a big help, then with the silicone treatment, got to get careful it slides so easily....a long way from your screen question though!

Mike
Mike
2001 U320 4010 Build 5878 (Gus)
Wrangle Unlimited Toad
Nacogdoches

Re: Window screen

Reply #7 –
As I was looking at how to get the screen out I did see that some cleaning is needed, so the project grows a bit to include some cleaning. I think that all windows will eventually get a removal and cleaning. I'm putting the spray information on my iPhone so the next time we're at Wal-Mart I can get some.

Re: Window screen

Reply #8 –
The first time we removed screens, we scratched the location in the frame. And to clean we take a hose, soap & water at an outside campground faucet, shake out and put them back.

Re: Window screen

Reply #9 –
I took the screen out, thinking that I would need to take it to the hardware store. After the screen was out I was able to put the screen back into frame, so all is reassembled. Now that I know how to take things apart and put them back together again I'll clean and lube each window track.

Re: Window screen

Reply #10 –
@David FOT still carries the window tracks if you need some. A couple of mine where in pretty bad shape so I replaced them.

see ya
ken
The selected media item is not currently available.ken & dori hathaway & Big Agnes
🍺1992 U300 GrandVilla WTBI #4150 FOT FBP 2011
✨6V-92TA DDEC Parlor Coach 350HP Series 92
🏁2011 Nissan XTerra Pro-4X

Re: Window screen

Reply #11 –
Thanks, Ken. I hadn't thought about replacing them, since I've only had the one out, but good to know that FOT still has parts for our 21-year-old coach.