Skip to main content ↑ ↓
Topic: VMSpc Question (Read 611 times) previous topic - next topic

VMSpc Question

I am setting up a laptop to display my VMS and I can't get the volt meter and boost pressure to show up. Could someone provide me with their parameter settings for these two? They worked fine on my previous vms computer which just died.
thx
Rick & Deborah Webster
2002 3610 U320 #5964
2014 Jeep Wrangler Sahara JKU- 'Copperhead'
Richland Chambers Lake, East Texas

Re: VMSpc Question

Reply #1 –
Here is a link to VMSpc info including the manual.  (scroll down on page).

VMSpc Downloads | SilverLeaf Electronics, Inc.

Keith
Keith, Joyce & Smokey the Australian Cattle Dog
1995 U320 SE Extreme 40' WTBI Build # 4780, with a Honda CR-V hopefully still following behind.
Motorcade # 17030
FMCA # F422159

Re: VMSpc Question

Reply #2 –
When you have the VMS up on the computer go click on the column that says gauges- you can install any of the gauges there.  It is so easy even I was able to do it.

Good luck and have fun with it.
Ted & Karen
2001 U270 36' - sold after 12 years full timing

Re: VMSpc Question

Reply #3 –
I got everything I wanted working except the boost. The Silverleaf tech was perplexed also. I will keep messing with it.
Rick & Deborah Webster
2002 3610 U320 #5964
2014 Jeep Wrangler Sahara JKU- 'Copperhead'
Richland Chambers Lake, East Texas

Re: VMSpc Question

Reply #4 –

  Here is a screen shot of the Parameter Editor and values that work for me.
                      Hope it can help you.
                              Jim
Jim & Doreen
2003 U320

 "Too often I would hear men boast of the miles covered that day, rarely of what they had seen"
― Louis L'Amour