In Nac for work on the coach
We got here last Sunday (10 days ago) and spent a couple days at MOT. Engine and mechanical service, new water heater, and windshield.
We got to Xtreme this Sunday for work on our slide. All 4 sides will be repaired to fix delamination. Tim Fiedler's is just being finished for the same problem. My brother's was done in Feb. The side panels were stuck pretty good to the steel but not stuck at all to the foam filler, even though FOT used lots of glue. Rance is replacing the foam with foam and 3/4" plywood and then hand laying the fiberglas on top.
We're also getting some things done ourselves. It's rained everyday for the 2 weeks we've been in TX and we've found a couple of window leaks. We fixed two last weekend and decided to redo the gaskets on all the windows. I've found that every window has at least one corner where the gasket has shrunk into the curve and breached the seal. I'd suggest that everyone consider checking at least a window or 2 to see you you have the potential problem. You may be able to get an idea of the seal condition by gently running a very thin scraper blade or feeler gauge between the frame and the sidewall to see how far the gasket has shrunk. Ideally, the blade should not go in past the edge of the frame. If it goes in more than a 1/4" before it hits the gasket, I'd be concerned.
Some windows are easy to get out and some are tougher. I had to remove all the valences and window shades on each of them. The other hard part is getting all the old adhesive off before you put on the new gasket. Takes some time, solvent and scraping. I figure about 2 hours per window.
I've also sanded and repainted the entry step and will get new non-skid on in a couple of days.
Also plan to get up on the roof next week and caulk every joint.
Rich