ride height air

Topic: ride height air (Read 519 times) previous topic - next topic

ride height air

December 07, 2015, 07:13:23 pm

Just finished getting the ride height working and am mystified as to how I fixed it. I started the trouble shooting by pulling the 7 1/2 amp fuse and verifying it was good. Put it back in and went to start looking for the next step. When I started the engine it starting working for the first time. Could it have just been a bad connection on the fuse? or does the HWH computer reboot by pulling the fuse and that fixed it?

Re: ride height air

Reply #1 – December 07, 2015, 08:15:12 pm

Yes it reboots by pulling that fuse and also turning off the 12 Volt master switch at the door.

Re: ride height air

Reply #2 – December 07, 2015, 09:11:50 pm

I didn't turn off any power in my checking this out. Must have just been a coincidence.

Re: ride height air

Reply #3 – December 07, 2015, 09:56:33 pm

There are two sources of power to the HWH box. The one by the door may affect the leveling system (I never checked that), but the travel mode is powered by the chassis batteries and is activated when the key is on and the "air" switch in the leveling control panel is off, as far as I know.
Don

Quote from: Doug W. – December 07, 2015, 08:15:12 pm

Yes it reboots by pulling that fuse and also turning off the 12 Volt master switch at the door.

Foretravel Owners' Forum For owners and Fans of Foretravel Motorcoaches September 13, 2025 ...

ride height air

December 07, 2015, 07:13:23 pm

Re: ride height air

Reply #1 – December 07, 2015, 08:15:12 pm

Re: ride height air

Reply #2 – December 07, 2015, 09:11:50 pm

Re: ride height air

Reply #3 – December 07, 2015, 09:56:33 pm

Affiliate Notice