Foretravel Owners' Forum For owners and Fans of Foretravel Motorcoaches September 16, 2025 ...

Another Step Well Cover Question

January 14, 2016, 12:06:58 am

I had an air leak on the regulator for the step well and had to replace the regulator.

After installing the new Husky regulator, I could not set the pressure on the regulator as it bled pressure form the air system and then build back up until the cut off point for the d2 governor. I reviewed what I had done and figured out I put the regulator on backwards (air going in the discharge side). So, I turned the regulator around the way it should be but I am still getting the same issue.

What pressure should this regulator be set at and more importantly, would this incorrect installation damage the regulator?

jack

Quote Selected

Re: Another Step Well Cover Question

Reply #1 – January 14, 2016, 10:01:32 am

Mine is set at 60lbs. Doubt if it damadged the valve.
JohnH

Quote Selected

Re: Another Step Well Cover Question

Reply #2 – January 14, 2016, 10:32:17 am

I couldn't figure out why it would fluctuate as the compressor (engine) builds pressure up to 120 psi and then bleed it down to cut on the compressor.

Basically I guess I just can't get it to set at 60 psi.


jack

Quote Selected

Re: Another Step Well Cover Question

Reply #3 – January 14, 2016, 04:30:56 pm

Sounds like it may be faulty.  Take it back and put a new one on I think?

Keith

Quote Selected