Skip to main content ↑ ↓
Topic: Bathroom vanity fixture (Read 393 times) previous topic - next topic

Bathroom vanity fixture

We were cleaning and broke off an led replacement bulb in the brass three bulb fixture.

Cannot get the base out.  Bulb is gone as is the circuit board.

Any idea why it will not turn in the fixture?

The led bulbs have a white base that fits flush to the fixture. 

Went in in place of the team bulbs.  Never tried removing them.

?
"Riding and rejoicing"
Bob
1997 U320 40' Mid entry, build 5132,  wtbi ce27, 4th owner
2007 Solara convertible
2 prodeco tech outlaw ss electric bikes

1095 watts solar
08 Ls 460 and a sc430
2000 Ford F-250 superduty 4x4

Re: Bathroom vanity fixture

Reply #1 –
Bob,

Disclaimer:  Have not seen the exact LED you have.

Can you use a pair of needle nose pliers in the LED to remove it?
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: Bathroom vanity fixture

Reply #2 –
I have experienced bulb problem similar to yours in the past. Seems the base/bulb has to be pushed in and then turned, as there is a little return(?) in the paths the posts on the bulb base so the bulb does not just rotate and then pop out on its own from vibration. Try pushing the remainder of the base in and rotate backward from the installation direction.
Nitehawk,  Demolition Lady, & our NEW master, Zippy the speeding BB cat.
1989 Grand Villa 36' ORED
Oshkosh chassis, 8.2 DD V8
2006 Saturn Vue AWD

Re: Bathroom vanity fixture

Reply #3 –
Quote from: nitehawk –
I have experienced bulb problem similar to yours in the past. Seems the base/bulb has to be pushed in and then turned, as there is a little return(?) in the paths the posts on the bulb base so the bulb does not just rotate and then pop out on its own from vibration. Try pushing the remainder of the base in and rotate backward from the installation direction.

The white plastic base below the actual bulb was bottomed out.

Would not allow the needed movement in.

Squeezed the plastic part with a needle nose pliers and broke it off.

Squeezed the metal part in the fixture till it was flat then pushed it in and turned it till it was free.

New bulb went in fine and lights up.

Thanks for the help 
"Riding and rejoicing"
Bob
1997 U320 40' Mid entry, build 5132,  wtbi ce27, 4th owner
2007 Solara convertible
2 prodeco tech outlaw ss electric bikes

1095 watts solar
08 Ls 460 and a sc430
2000 Ford F-250 superduty 4x4