Skip to main content ↑ ↓
Topic: 95 u240 ride height adjustment (Read 536 times) previous topic - next topic

95 u240 ride height adjustment

Simple question,
        Is it possible to place and 1" thick square plate under torsion bar to raise ride height on rear of my 95 U240?  I do have 4 shims left on both sides to raise ride height, but I want another 1".
Pat/Blue Angel
1995 U240 36ft
MC# 16511
Build# 4653

Re: 95 u240 ride height adjustment

Reply #1 –
Pat,
What are your ride height measurements now?

And, no have never heard of using a plate under the torsilastic beam.

Several have added two air bags to each side in the rear.
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: 95 u240 ride height adjustment

Reply #2 –
Hello Brett,

 Thanks for the quick reply
  I don't remember them right now, but it is sagging a little.  I now have 4 shims left and  as I remember that would not get it up to the correct height.  So I was looking,  the bar just sets on top of the axle, so why not put a shim under it on its mount?  Bags ruin the purpose of the torsilastic beam construction, no maintenance .  Shims would be lots cheaper fix.
Pat/Blue Angel
1995 U240 36ft
MC# 16511
Build# 4653

Re: 95 u240 ride height adjustment

Reply #3 –
Pat,

Don't overthink this.  Just remove the remaining shims and that should get you very close to the 1" that you need.  If/when you get to the point where the height is below 32", and you don't want to "spring" for new Torsilastic beams, adding air bag helper springs would definitely be a good solution.  Putting spacers in could buy you a little time, but it take very little extra labor to replace the beams.  I replaced our tired original 15,000# beams last year with the 19,000# beams.  In our case, the ride and handling really improved.
Dave and Kelli
1997 U295 40' Build #5188 CSGI
1995 U240 36' Build #4621 SBID-SOLD
2006 Jeep Wrangler Rubicon

Re: 95 u240 ride height adjustment

Reply #4 –
Dave,

Did you go with the new torsilastic springs from Sulastic?
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: 95 u240 ride height adjustment

Reply #5 –
No, thankfully the PO purchased a set when the original supply was drying up and they came with the coach :)
Dave and Kelli
1997 U295 40' Build #5188 CSGI
1995 U240 36' Build #4621 SBID-SOLD
2006 Jeep Wrangler Rubicon

Re: 95 u240 ride height adjustment

Reply #6 –
One smart PO!
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020

Re: 95 u240 ride height adjustment

Reply #7 –
Quote from: Dave Larsen –
No, thankfully the PO purchased a set when the original supply was drying up and they came with the coach :)

You look at U-240 coaches for sale, and, thanks to some smart cookies, you don't have to think, "wow, that coach sure is a low-rider".  ^.^d  ^.^d
1993 U-240 "La Villa Grande"..CAT 3116 w/ Pacbrake PRXB...Allison 3060 6-speed..
Previous: 1983 Airstream 310 turbo diesel, 1979 Airstream 280 turbo diesel
                                      Build # 4297
                                      PNW natives
                      Home base:  'Cactus Hug' (Ajo, Arizona)
                        DW Judy & Chet the wonder dog
                        Full-Timers 'Sailing the asphalt sea'