Skip to main content ↑ ↓
Topic: Bulkhead inspection question (Read 1206 times) previous topic - next topic - Topic derived from 1991 - 1995 Uni home ...

Bulkhead inspection question

Is there a place that I can get a technical description of the bulkhead inspection. I have been an aircraft mechanic for most of my adult life and would feel most comfortable looking and understanding for myself. I drove truck summers to get through college and rather like the mechanical injectors of the eighty's and ninety's vs. "modern" computerised. The new system is better, but am an old dog and I don't know those tricks (yet). Electrical may be the way for me. I prefer airbags. So that's where I think I am in search.  Can somebody help steer me around a little. I looked at a couple Monacos, just not the same thing, but nice

Re: Bulkhead inspection question

Reply #1 –
The very top of Technical has a very good explanation "bulkhead repair a comprehensive look"
1999 40 ft. U-320 wtfe build 5563 Chuck & Lynda's "Rollin' Inn"  2030 watts solar
prev. mh's 71 GMC 5 yrs. 73 Pace Setter 1 yr. 78 Vogue 5 yrs 81 FTX 40ft all electric 18 yrs. 1996 Monaco Signature 3 yrs.
2014 Grand Cherokee Overland
Dream as if you will live forever. Live as if you will die today.  James Dean

Re: Bulkhead inspection question

Reply #2 –
Thanks

Re: Bulkhead inspection question

Reply #3 –
Quote from: Kay –
Is there a place that I can get a technical description of the bulkhead inspection. I have been an aircraft mechanic for most of my adult life and would feel most comfortable looking and understanding for myself. I drove truck summers to get through college and rather like the mechanical injectors of the eighty's and ninety's vs. "modern" computerised. The new system is better, but am an old dog and I don't know those tricks (yet). Electrical may be the way for me. I prefer airbags. So that's where I think I am in search.  Can somebody help steer me around a little. I looked at a couple Monacos, just not the same thing, but nice
Kay,

Most days, I've got my head stuck in one Grumman AA-5 or another so know the mechanical preference. I do love the "glass cockpit" as it takes away 90% of the flying workload. Love putting my finger on the destination and all the work is done in less than a second. Weight and balance is no longer a chore. Still getting use to the engine analyzer and all of it's functions.

Study the bulkhead issue very carefully. Just as you would not buy a Florida aircraft, the northern states are sketchy for Foretravels. It's the number one issue in your search.

I've had both mechanical and DDEC Detroits and like the electronic engine better. The Pro-Link 9000 is not much harder to use than a battery load checker. Takes hours of troubleshooting and reduces it to five or ten minutes. Plus, I don't know of any DDEC Detroits have have lost an ECU. Sure that some have but they have not shown up on the forum. A bad injector or wiring harness won't fry the ECU.

Pierce

Pierce and Gaylie Stewart
'93 U300/36 WTBI
Detroit 6V-92TA Jake
1140 watts on the roof
SBFD (ret)

Re: Bulkhead inspection question

Reply #4 –
Check out the above link and exercise the search button.  Sit back with the beverage of choice and read.

I do not think there is a "Document" that outlines the Inspection process.  Lots of variables.  :)
Scott & Carol Seibert
2001 42' double slide U320 - Sold
Previous - 2002 36' U320

Re: Bulkhead inspection question

Reply #5 –


Scott,

This is the last two feet of my water compartment floor. The area that people look at (under the coach to check for rust jacking) that is huck bolted to the left side of this floor section.
In my case there was no rust jacking or opening of the that angle iron junction. Suffice to say...observing no separation of the huck bolted angle iron without taking down the fiber glass sheeting under the coach is no guarantee of healthy structure.
Jim

2002U330
Jim Frerichs
2002 U320 42'

Re: Bulkhead inspection question

Reply #6 –
 ^.^d
Scott & Carol Seibert
2001 42' double slide U320 - Sold
Previous - 2002 36' U320