Skip to main content
Topic: Retarder issue (Read 896 times) previous topic - next topic

Retarder issue

While driving today in northwestern Colorado I had this happen a few times:  When I would pull the retarder joystick a click or more to slow down on descents or curves sometimes the cruise control would not disengage, but once I tapped the brakes then the cruise would disengage and the retarder would work.  It wasn't every time, most times the cruise would disengage and the retarder would slow me down. 
So where should I start looking?  the retarder joystick?  or the cruise control?
Any thoughts?
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
no longer 1999 36' U320 build #5522
2013 Rzr 570 & 2018 Ranger XP1000
2006 Lexus GX470
2011 Tahoe LT 4x4
Previous 1998 45' 2 slide Newell, 1993 39' Newell

Re: Retarder issue

Reply #1
I believe the problem might be "zero throttle".  Retarder kicks in once it sees zero throttle.
Dan - Full timing since 2009
2003 U320 40' Tag 2 slide

Re: Retarder issue

Reply #2
Mine acts the same.

Re: Retarder issue

Reply #3
My understanding is that the retarder is not to be used with the cruise control (and vice versa).
 
Trent
Trent and Jean Eyler
2000  U295  4003  WTFE  ISC  350
Build#5603 MC#17385

Re: Retarder issue

Reply #4
Zero throttle?  So if there is no throttle (or load) on the engine then the retarder will kick in whether cruise is on or not?
That could explain why sometimes it will kick in and other times it won't.
Yesterday's drive down CO Hwy 13 was following the Yampa river and had lots of curves with some up/downs. 
I'll pay more attention on Monday when we continue.
Thanks!
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
no longer 1999 36' U320 build #5522
2013 Rzr 570 & 2018 Ranger XP1000
2006 Lexus GX470
2011 Tahoe LT 4x4
Previous 1998 45' 2 slide Newell, 1993 39' Newell

Re: Retarder issue

Reply #5
Zero throttle?  So if there is no throttle (or load) on the engine then the retarder will kick in whether cruise is on or not?

Yes, I think that is the case.  Confused me at first as well.
Dan - Full timing since 2009
2003 U320 40' Tag 2 slide

Re: Retarder issue

Reply #6
 Ours is setup so that the retarder works with the cruise control in use.  Any zero throttle and the retarder comes on if powered on and the joystick off its resting position.  Brake lights work when the retarder is on as far as I know also.

Being tugged back on slight downhills reminds me to move the joystick to off if I do not want to lose that particular amount of speed.

"Riding and rejoicing"
Bob
1997 U320 40' Mid entry, build 5132,  wtbi ce27, 4th owner
2007 Solara convertible
2 prodeco tech outlaw ss electric bikes

1095 watts solar
08 Ls 460 and a sc430
2000 Ford F-250 superduty 4x4

Re: Retarder issue

Reply #7
There is a relay in the lower left compartment under the driver. It applies the brake lights when the retarder is activated, which turns the cruise off. Maybe the relay is going bad, or you may be having a brake light issue.
I have mine unplugged, because every burp in the road kicks the cruise off. I always make sure I apply the brakes when I am actually stopping, so those behind me see my brake lights.
Chris
Chris and Tammy White  CDA Idaho
Previous owners 1997 U295 36' 3126 Cat 300 HP Build # 4998
Former Foretravel tech & RVIA certified tech
Former owner Custom Satellite home/RV satellites 
Former owner Vans LTD  van conversions
Unemployed, panhandler, drag racer NHRA #6348

Re: Retarder issue

Reply #8
On my coach, the cruise control is "subservient"  to any braking devise.  If the retarder is in any position other than off, I cannot set the cruise.  If I am in cruise and the retarder is engaged (I move the lever) with zero throttle, the cruise goes off.  I prefer this as a safety measure.  My cruise won't hold speed if going downhill, so I  usually have it off when going through the mountains.
2000 U320 mid entry  #5688
2006 Jeep Liberty


USMCR retired
SDFD retired
FEMA US&R TF8

Re: Retarder issue

Reply #9
i surely respect the safety aspect.  But if you drove mine with the retarder being usable with the cruise you would have a comparison you might like.

I like that I can turn off the cruise control power on the steering wheel and the m11 retains the last speed setting in its memory and when the power is turned back on the resume function returns the coach to the previous speed without hitting the brake pedal and flashing the brake lights unnecessarily.

Going down grades with the cruise engaged and the retarder engaged allows me to control the speed with the retarder wand primarily.  Off the coach can pick up some free mileage during the over run.

Retarder working with cruise helps maintain a set speed if on that may avert contact with the speed limit authorities.

Some locales in rural area have low or zero tolerance to overrunning their speed limits.

Good way to tell if the road you are on is really down hill versus guessing.  Retarder tugging back is more noticeable than the throttle just returning to zero.

Much easier to drive in moderate traffic and elevation changes...
"Riding and rejoicing"
Bob
1997 U320 40' Mid entry, build 5132,  wtbi ce27, 4th owner
2007 Solara convertible
2 prodeco tech outlaw ss electric bikes

1095 watts solar
08 Ls 460 and a sc430
2000 Ford F-250 superduty 4x4

Re: Retarder issue

Reply #10
Dan you're right, my retarder is working like you said, it kicks in when there is zero throttle.
Thanks!
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
no longer 1999 36' U320 build #5522
2013 Rzr 570 & 2018 Ranger XP1000
2006 Lexus GX470
2011 Tahoe LT 4x4
Previous 1998 45' 2 slide Newell, 1993 39' Newell