Cummins M-11 222 Fault Code- Ambient Air Pressure Sensor
So, thankfully, I was able to locate the Sensor Codes on this site! I made it 400 miles into my 2,800 Mile Trek with now Major Issues? Then, I got the dreaded Stop Engine Light Illuminated! BYW My particular Fault code Switch Setting was the Top Switch in the DOWN Position, and I Mashed the Bottom Momentary Switch once! Took a while to get the code flash. I have a small Bulb that has always just stayed illuminated under the dash, and it Never Flashed! What I got instead was the Check Engine light Flashed with a Series of 2 2 2 then the Stop Engine came on again. So if someone could please explain the Proper Sequence, to retrieve all codes stored, I'd appreciate that!
Also, is their any resource to find the Location of that sensor, perhaps? I see a few codes dedicate to the Ambient Air Pressure Sensor, as well, and I believe that they may be other sensors? The light only briefly comes on then goes off, so not always a Solid Light!
Also, would an Ambient Air Condition be related to Intake Air? A few months back, I did have a Birds nest that I removed, on the Intake all the way down to the Filter! I put a New Filter, in, after taking a Plumbing Snake as far as I could. There seems to be a "SHELF" that is about 2 feet down from the Top, right after the 90 degree bend heading down! I used a Vacuum Hose and went Up, and Down and felt I got all debris from that nest! Seems that the screen, on one side had lost it's grip, and a Bird was bale to get in there! (You might want to look for that!) I Took Silicone, and bedded them both back into position, By Pulling on the screen with wire! They are in there pretty good now, but is this an actual Intake issue, perhaps? I put in a New Filter, and the Old one had no evidence of bird nest material, so that was good!