Skip to main content
Topic: No Signal (Read 402 times) previous topic - next topic

No Signal

The previous owner was proud that he installed a backup camera in the coach....all by himself. Unfortunately, he left me no paperwork as to how he did it or what brand he used. Yesterday, after years of good service.....it quit on me, with the screen lighting up blue and the words " no service ". I am at a loss. I can't tell you how dependent I am using the camera, not only to check to see if I still am pulling the toad, but for checking oncoming traffic, police cars and when it's ok to reenter my lane, after a pass. Question is.....what do I do now??!!!!  We are headed towards Houston, so I am sure someone knows how to check the system out. Is it time to add some side cameras and redo the installation??? HELP!!!!!!
Glenn and Amy Beinfest
2001 36' U320
#5812
2014 Honda CRV

No Whining on the YACHT

Re: No Signal

Reply #1
If you can, check to see if the camera is getting power then that is the first step. Also need to check the signal connections between the camera and the dash monitor.
David and Carolyn Osborn
1995 U320C SE 40' Build 4726 Feb 1995
FMCA 147762
Motorcade 17186

Re: No Signal

Reply #2
go to the rear and check the connection but i would start looking under the dash to see if it wiggled loose

Re: No Signal

Reply #3
Yes, absolutely start by checking connections at both back (camera access panel in center of bed overhead storage area) and in the dash area from wiring into Audit to monitor.
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020