Skip to main content
Topic: Magnum ms2812 and new batteries (Read 793 times) previous topic - next topic

Magnum ms2812 and new batteries

House batteries are 7 years old and have been abused. Will probably replace them this Fall when going through Oregon.

Magnum inverter manual says to prevent damage to the inverter "to remove battery power from the inverter disconnect the battery positive connection before the negative connection."

So, first disconnect the dc positive lead at the inverter, then the negative leads at the battery bank, then the positive leads at the battery bank? Should I expect a tech to do it this way?
Mike & Molly Patronick
2001 U320 40'
2011 Forester

Re: Magnum ms2812 and new batteries

Reply #1
I would disconnect the positive lead at the battery bank, otherwise you have a loose, hot cable when you disconnect from the inverter.  No need to do anything at the inverter if you're just installing new batteries.  Most techs should know what to do but you can't always count on that.  Discuss it with them and have them write it on the work order if you're concerned about it.

Re: Magnum ms2812 and new batteries

Reply #2
Do you know by whom, or where, your MS2812 was installed?  In all but the most amateurish installation, I would expect (hope) to find a manual disconnect switch between the batteries and the inverter.  If you have such a switch, simply open it to isolate batteries.

See red cable in diagram at the bottom of this page:

Magnum MS2812 Inverter Charger

It would look like the big red switch in the photo (our coach).  Other items are the fuse, shunt, and (yellow) disconnects for solar controllers.
1993 U280 SE 40' WTBI, Build: 4359
C8.3 300hp, 6-Speed, Exhaust Brake
960 watts on the roof (6 x 160)
Sorento (or BOLT) on a Kar Kaddy SS
"Nature abhors a vacuum"

Re: Magnum ms2812 and new batteries

Reply #3
Definitely do it in the sequence the manual says.  A friend recently had to replace his Magnum by not following the recommendations.
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
no longer 1999 36' U320 build #5522
2013 Rzr 570 & 2018 Ranger XP1000
2006 Lexus GX470
2011 Tahoe LT 4x4
Previous 1998 45' 2 slide Newell, 1993 39' Newell

Re: Magnum ms2812 and new batteries

Reply #4
Make sure the 120v circuit breaker to the inverter is off as well.
Roger Engdahl and Susan Green
2001 U320 3610 #5879 (Home2) - 2014 Jeep Cherokee or 2018 F150
Hastings, MN

Re: Magnum ms2812 and new batteries

Reply #5
Inverter was installed in 2012 by Keith Risch at MOT. Everything was left OEM except the new inverter and remote.

Talked to Magnum tech support. First suggestion was pull the fuse in the positive cable. Next suggestion was disconnect positive cable at inverter. Will try positive cable at inverter first, easier to get to. Then do traditional battery disconnection.

Thanks
Mike & Molly Patronick
2001 U320 40'
2011 Forester