Skip to main content ↑ ↓
Topic: REMCO switch? (Read 1199 times) previous topic - next topic

REMCO switch?

On the lower part of my dash is a REMCO switch. What is that for?
I took a picture but not sure that it came through.
Rick & MJ Berry
1998 U320 40'
Ohio

Re: REMCO switch?

Reply #2 –
Store : Remco

Re: REMCO switch?

Reply #3 –
Should that be on and what does it do in regards to the transmission.
Why is the a on off switch?
Rick & MJ Berry
1998 U320 40'
Ohio

Re: REMCO switch?

Reply #4 –
I believe it is the on-off switch for a remco transmission pump.  It is used to pump transmission fluid in your toad if it doesn't have 4x4 transfer case that can be put in neutral thus allowing you to tow a car that was not designed to be towed.  If you don't have this car then you don't need the switch.  You can remove it.
2002 36' U270 Foretravel

Re: REMCO switch?

Reply #5 –
Once installed on toad with automatic transmission provides transmission oil pressure from a pump. $1600 mod to tow vehicle.

Re: REMCO switch?

Reply #6 –
We do want to tow a vehicle.
I wonder about all of the particulars.
Rick & MJ Berry
1998 U320 40'
Ohio

Re: REMCO switch?

Reply #8 –
Rick, we towed with a dolly for a couple of years, then DW wanted a new vehicle SUV type.  I said great but it had to be a 4 wheel drive with a neutron in the transfer case.  I just like the ability to put everything in neutral (front and rear wheels) put transmission in park flip a switch then drive away.  the motorhome magazine towing guide is very good place to start your search.
BTW we toe a 2015 jeep cherokee, wasn't my first choice, but others didn't have neutral in transfer case.
Chris
1999 U 320 DGFE
Build Number 5523
Chris & Elka Lang
In the field, Lonoke AR

Re: REMCO switch?

Reply #9 –
Rick, the REMCO site is one of the places to go to check on whether your current vehicle can be safely towed four-down. Another is the FMCA towing guide. The MotorHome magazine mentioned above would also work. I use REMCO simply because it is so easy. Just put in the information for your current vehicle. If you are considering a change, put in your preferred candidate. Depending on your vehicle, you will get one of three possible answers:
1. your vehicle is towable as is
2. your vehicle needs a pump
3. your vehicle must be trailered.

Of course, for your current vehicle the easiest way to find out is to look in the owner's manual.

There are some things that might affect your decision. For example, the owner's manual for any Mini will say that it can NOT be towed four-down. REMCO says the manual transmission ones can be. You see lots of Minis pushing motor homes. I'm guessing that if you bought a new Mini and towed it the dealer would tell you that you have voided the warranty. If you bought a used Mini with no warranty the choice is yours.

BTW, we started out towing a 2012 Jeep Liberty. A couple of years ago it developed an expensive-sounding noise, so we now tow a 2015 Lincoln MKT. This is the basic model, so it is front wheel drive only, not all-wheel drive. Hook it up, put it in neutral, and away we go. Yes, we have to run it a bit in each gear, but expect for one time where we had an overnight stop in a pull-thru site, we always have to drive the car at least a little bit to hook up, so that isn't an issue.

Re: REMCO switch?

Reply #10 –
Although you can check all the sites mentioned for towing info, I've found Remco tends to favor vehicles they sell equip for, so like anything else check all your sources.  I also like the Roadmaster site.

I've used a lot of their equipment, all with good results.  Their company has a lot of integrity, great before and after sale service.

Homepage
97 U295 40, Build #5040, 6C8.3 325 HP
Oregon Continuous Traveler
Samsung Residential #RF20HFENBSR,
Xantrex SW2012, (3)AGM8D Hse, (2)AGM Grp24 Eng, Victron BMV-712, 1800w Solar 4 LG & 2 Sunpower
Extreme Full Body Pt w/hdlmps, new furn/floor, 4 down Lexus 2004 GX470 AWD curb weight 4,740 lbs
Prev: 1990 Barth, 10L 300 2 yrs; 91&92 Monaco Signature, 10 yrs, 10L C 300 &  6C8.3 300; 1997 ForeT 6C8.3 325 since May 2017.  Employed by Guaranty RV 14+ yrs.  Former VW New Car Dlr/Service Dlr, Sales Mgr, Rv Sales, and Service Adviser from 1968-2017
"Don't criticize what you can't understand" Bob Dylan

Re: REMCO switch?

Reply #11 –
Quote from: 18360 –
Should that be on and what does it do in regards to the transmission.
Why is the a on off switch?

The Remco systems uses a pressure switch on the pump output side to provide verification back to the driver that the transmission is being lubricated in case the pump or cable connection fail.  The switch is there for when you are not towing or your toad no longer has the system.
John Fitzgerald
1991 U300 (SAI) Side Aisle Island Bed 40'
Detroit 6V92 with Allison Retarder
Meridian (Boise), Idaho