Skip to main content ↑ ↓
Topic: Remote start stopped working (Read 516 times) previous topic - next topic

Remote start stopped working

Good evening. I replaced all 3 belts today. When I went to try the remote start in the engine bay, it no longer clicks or starts. I've checked and all the wires seem attached to the panel. Is there a fuse somewhere or breaker? I cut a few ty-raps out that were really tight and replaced them with a bit of slack. Unless it's a coincidence and quit but mighty suspicious. It worked fine a few days ago. I disconnected the AC single wire to reroute it at the connector but shouldn't have anything to do with the start
Thanks
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.

Re: Remote start stopped working

Reply #1 –
I would check the remote start switch to see if it is functioning then check the aux. start solenoid to see if it has died.

Mike
Pamela & Mike 97 U 320

"It's not what happens to you, but how you react to it that matters."

Re: Remote start stopped working

Reply #2 –
Is it in neutral?
Tim Dianics
Pam Sapienza
Vader PupZilla Labrador Canine Beast (AKA Pup)
Columbia, MO
1996 U320 4000
2021 Jeep Gladiator, Diesel

Re: Remote start stopped working

Reply #4 –
Don't need ignition on. It actually locks the key out when activated. Starts fine with key inside. where is the aux.start solenoid? In the engine bay I presume? It's very odd it quit when I worked on changing the belts. I'll see if I have power to the switch tomorrow, Any fuse? for the aux. start relay? I no longer hear the relay click wherever it was when I flip the switch to on position.
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.

Re: Remote start stopped working

Reply #5 –
Quote from: dans96u295ft –
where is the aux.start solenoid?
Any fuse? for the aux. start relay

Located on the Isolator board, (if it hasn't been moved) it is behind the bay door that is behind the drivers side rear door. (the one behind the rear wheels)

Yes it should be breaker #19 hid behind the kick panel in front of the passengers seat. OEM this is a self resetting breaker but could have gone bad.

Mike
Pamela & Mike 97 U 320

"It's not what happens to you, but how you react to it that matters."

Re: Remote start stopped working

Reply #6 –
I was under the impression that remote start won't work unless ignition key is in the on position.
1998 36 foot U270 Build No. 5328 WTFE, 900 watts solar, Victron controller, B2B, bat monitor, 600 AMPH lithium with 2018 Chevy Colorado toad, SKP #110239, Motorcade #17781, 2021 Escape 17B for when Coach is broken down and campsites are too small, retired and full-timer since Dec. 2020. Part of RV family since 1963.

Re: Remote start stopped working

Reply #7 –
Quote from: Realmccoy –
I was under the impression that remote start won't work unless ignition key is in the on position.
That's the way mine works.
1999 40 ft. U-320 wtfe build 5563 Chuck & Lynda's "Rollin' Inn"  2030 watts solar
prev. mh's 71 GMC 5 yrs. 73 Pace Setter 1 yr. 78 Vogue 5 yrs 81 FTX 40ft all electric 18 yrs. 1996 Monaco Signature 3 yrs.
2014 Grand Cherokee Overland
Dream as if you will live forever. Live as if you will die today.  James Dean

Re: Remote start stopped working

Reply #8 –
My 1996 Cummins has never needed the key on to avoid someone starting it when your working in the engine bay
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.

Re: Remote start stopped working

Reply #9 –
The later coaches don't have a switch, just start and stop buttons.
1999 40 ft. U-320 wtfe build 5563 Chuck & Lynda's "Rollin' Inn"  2030 watts solar
prev. mh's 71 GMC 5 yrs. 73 Pace Setter 1 yr. 78 Vogue 5 yrs 81 FTX 40ft all electric 18 yrs. 1996 Monaco Signature 3 yrs.
2014 Grand Cherokee Overland
Dream as if you will live forever. Live as if you will die today.  James Dean

Re: Remote start stopped working

Reply #10 –
For safety and security the ignition has to be on as far as I know.  Unless someone rewired it
"Riding and rejoicing"
Bob
1997 U320 40' Mid entry, build 5132,  wtbi ce27, 4th owner
2007 Solara convertible
2 prodeco tech outlaw ss electric bikes

1095 watts solar
08 Ls 460 and a sc430
2000 Ford F-250 superduty 4x4

Re: Remote start stopped working

Reply #11 –
I am on the road and don't have all my prints with me. If someone has a copy of the A-4752 print for a '96 coach (IIRC) it will show that the remote start switch/button is wired in after the keyed ignition switch in the dash. So you shouldn't need the key to start it with the remote.

Just an FYI the power to the OEM fuel Winn fuel filter also came off the power side of the start button on those year coaches.

Mike
Pamela & Mike 97 U 320

"It's not what happens to you, but how you react to it that matters."

Re: Remote start stopped working

Reply #12 –
Interesting. Never needed to have keyed ignition on period. If I figure it out today, i'll be sure and post the results
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.

Re: Remote start stopped working

Reply #13 –
Quote from: dans96u295ft –
Interesting. Never needed to have keyed ignition on period. If I figure it out today, i'll be sure and post the results
Our '95 U240 will also start with the remote switch even without the key in the ignition.
Dave and Kelli
1997 U295 40' Build #5188 CSGI
1995 U240 36' Build #4621 SBID-SOLD
2006 Jeep Wrangler Rubicon

Re: Remote start stopped working

Reply #14 –
Related story: Took my Monaco rv to local diesel injection pump and service shop. When I picked it up they started the engine from the outside, pulled it up front for me to take to my storage.  Next time I went to start at storage yard, it would not start. Called for roadside service from another HD truck repair garage. He came, jumped it with monster roadside service truck, and nothing.  After removing  service truck jump, he told me to go in rv and start. It did, telling me what the other shop had done, we both had a laugh.  He refused to charge me as the other shop were friends of his.
97 U295 40, Build #5040, 6C8.3 325 HP
Oregon Continuous Traveler
Samsung Residential #RF20HFENBSR,
Xantrex SW2012, (3)AGM8D Hse, (2)AGM Grp24 Eng, Victron BMV-712, 1800w Solar 4 LG & 2 Sunpower
Extreme Full Body Pt w/hdlmps, new furn/floor, 4 down Lexus 2004 GX470 AWD curb weight 4,740 lbs
Prev: 1990 Barth, 10L 300 2 yrs; 91&92 Monaco Signature, 10 yrs, 10L C 300 &  6C8.3 300; 1997 ForeT 6C8.3 325 since May 2017.  Employed by Guaranty RV 14+ yrs.  Former VW New Car Dlr/Service Dlr, Sales Mgr, Rv Sales, and Service Adviser from 1968-2017
"Don't criticize what you can't understand" Bob Dylan

Re: Remote start stopped working

Reply #15 –
 :)  ;) Ok. Update. When replacing the belts I wiggled the wires going to the remote starter panel and ty-wrapped them better. There was severe corrosion on the back side of the toggle switch and one of the terminals fell off. Got a new Cole-Hersee 25amp toggle, cleaned all the connections and it works fine. It works without the key to start and stop the engine. If the ignition is on, it will start the engine but you can't turn it off without the key turned off.  So no need for the keyed ignition on this model.
Thanks for all the help
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.