Skip to main content ↑ ↓
Topic: Re:Aqua Hot wiring harness question (Read 541 times) previous topic - next topic - Topic derived from Re: Roof construction

Re:Aqua Hot wiring harness question

After dismantle of my burner, I replaced the bearings, fuel pump, nozzle etc. but upon further inspection I noticed two frail wires which have brittle insulation and it is cracked exposing the wire core.  My intent is to replace the brittle wires and connectors.  Does anyone know if these are some type of special high temp wires or connectors that must be used? I looked at the cost of a replacement harness and swallowed pretty hard?

Re: Re:Aqua Hot wiring harness question

Reply #1 –
Check with Rudy on this forum!

Re: Re:Aqua Hot wiring harness question

Reply #2 –
I did send him a PM. Ty

Re:Aqua Hot wiring harness question

Reply #3 –
I replaced those wires and used regular wire if those connectors go to the coil.