Norgren Valve Electrical Connectioin

Skip to main content ↑ ↓

Topic: Norgren Valve Electrical Connectioin (Read 321 times) previous topic - next topic

Norgren Valve Electrical Connectioin

March 15, 2021, 12:55:08 pm

I am in the process of removing the Norgren valve for my step cover and cannot figure out how to unplug the electrical wires from the body of the valve. Any insight would be appreciated. Thanks

Richard

Re: Norgren Valve Electrical Connectioin

Reply #1 – March 15, 2021, 01:39:56 pm

I just cut the 2 wires and used butt connectors when I reconnected. I moved my valve from under the steps to behind the box.

Re: Norgren Valve Electrical Connectioin

Reply #2 – March 15, 2021, 02:04:51 pm

This subject was discussed here about a week ago;

Step Air Pressure Regulator

Re: Norgren Valve Electrical Connectioin

Reply #3 – March 15, 2021, 02:12:16 pm

Thanks for the response Chuck. Actually I just found a Phillips screw under a layer of dirt. The screw holds the electrical plug in place.
so problem solved.

I read, with interest, the thread last week. I just had not noticed information about how the electrical plug was held in place.

Richard

Affiliate Notice

ForeForums is user-supported. When you purchase through some links on our site, we may earn an affiliate commission at no cost to you. As an Amazon Associate I earn from qualifying purchases.