Skip to main content
Topic: Microwave / Convection Oven; no power (Read 476 times) previous topic - next topic

Microwave / Convection Oven; no power

We were using the convection oven heating up some "Bush" beans.
In the midst of it the power went out. 
Luckily the beans were heated, and we were able to enjoy them but at some point we lost power to it.
I tested the plug and there is power at that source; however, the small white surge protector between the wall outlet and the microwave doesn't work anymore.  So, plugged the microwave directly into the outlet and nothing.
So, something must have happened inside.
I think it is time for a new one; it is the original Sharp from '98.
But before I purchase a new one does anyone have any suggestions for an easy fix.
I saw a previous post on the choice for a new one.

Thanks
Rick & MJ Berry
1998 U320 40'
Ohio

Re: Microwave / Convection Oven; no power

Reply #1
I have repaired microwaves before and they're all pretty similar and the technology hasn't really changed. Discharging the capacitor is fun if you like to live dangerously. You're probably better off looking to youtube for a step by step troubleshooting guide. You'll need a volt meter to test all the different components.

Personally, at 20+ years old, I'd just replace it because something else is soon to fail.
1987 Grand Villa ORED
2001 U320 4010

Not all that wander are lost... but I often am.

Re: Microwave / Convection Oven; no power

Reply #2
If you decide on a new one, the Sharp model 1818lsy will be a direct fit. It may even fit your existing mounting plate. I was able to use the old plate when I removed our old Sharp.  It wasn't too difficult, but a little heavy, so an extra set of hands helps.  Here's a picture of the new one.
Mark & Bev
2001 U295 36' Slide
Cummins ISC 8.3 350HP
Build #5802
Jeep Wrangler Toad

Re: Microwave / Convection Oven; no power

Reply #3
There is a replaceable fuse behind the control panel. Sometimes the fuse holder metal prongs get weak. Plug the microwave into a different outlet with an extension cord to test...

Earlier model years used different one-piece wall mount bracket that have two vertical long spring-release bolts with bolt heads next to wall, maybe with a plastic cover. Later wall mount is two-piece with long angled bolts with bolt heads mid-point located above side filter.

Re: Microwave / Convection Oven; no power

Reply #4
Yep. Replaced mine with a Sharp but needed to use new mounting plate
1996 U295-36, Cummins 300hp, 8.3. Build number 4864. Vin number 1F97D536XTNO54271. Purchased October 31, 2019.

Re: Microwave / Convection Oven; no power

Reply #5
Is that wall plug on a gfi?
John Duld
1995 U320C SE 40'

Re: Microwave / Convection Oven; no power

Reply #6
Yup, just plug something else into the outlet and verify the outlet is HOT.
Brett Wolfe
EX: 1993 U240
Moderator, ForeForum 2001-
Moderator Diesel RV Club 2002-
Moderator, FMCA Forum 2009-2020
Chairman FMCA Technical Advisory Committee 2011-2020