Skip to main content ↑ ↓
Topic: Fridge Eye Brow Question (Read 397 times) previous topic - next topic

Fridge Eye Brow Question

My Dometic RM7130  eye brow panel is acting up . Poor button response and when ambient temps are low it will cycle between Gas/Electric mode. Would be safe to spray an electrical cleaner into the button are to see if that would cure it ?

Thoughts appreciated.

Hans
Hans & Marjet
1995 U300 "Ben" (#4719)
3176B Cat,4060HD,Jake
SKP#139131
Motorcade#17579
2006 Honda Element (towed)

Re: Fridge Eye Brow Question

Reply #1 –
I would clean the connections at the eyebrow and at the back of the fridge to control board along with ground at back since it's cycling back and forth.
1998 36 foot U270 Build No. 5328 WTFE, 900 watts solar, Victron controller, B2B, bat monitor, 600 AMPH lithium with 2018 Chevy Colorado toad, SKP #110239, Motorcade #17781, 2021 Escape 17B for when Coach is broken down and campsites are too small, retired and full-timer since Dec. 2020. Part of RV family since 1963.

Re: Fridge Eye Brow Question

Reply #2 –
Hans,

Can you post a pic of your fridge and eyebrow?

Mike
Pamela & Mike 97 U 320

"It's not what happens to you, but how you react to it that matters."

Re: Fridge Eye Brow Question

Reply #3 –
Here you go Mike...
Hans & Marjet
1995 U300 "Ben" (#4719)
3176B Cat,4060HD,Jake
SKP#139131
Motorcade#17579
2006 Honda Element (towed)

Re: Fridge Eye Brow Question

Reply #4 –
When you take it off look around the backside and see if you can see a part number.

Mike
Pamela & Mike 97 U 320

"It's not what happens to you, but how you react to it that matters."