Skip to main content ↑ ↓
Topic: Ignition power/wire for fass fuel system  (Read 216 times) previous topic - next topic

Ignition power/wire for fass fuel system

Ok friends
I've figured out all information to install my new fass fuel system on my 1999 u320 ISM/450 except were is best to hook up the ignition on power. I won't need the air purge button on the back so should I use it or ? 
Any ideas

Thanks

James
Now 1999 U320 36' with ISM/M11
600 amps hours of lithium ion batteries.
Jeep gladiator tow vehicle for exploring.

Re: Ignition power/wire for fass fuel system

Reply #1 –
As mentioned on the next post, easy to pick up ignition signal from remote start.
1998 36 foot U270 Build No. 5328 WTFE, 900 watts solar, Victron controller, B2B, bat monitor, 600 AMPH lithium with 2018 Chevy Colorado toad, SKP #110239, Motorcade #17781, 2021 Escape 17B for when Coach is broken down and campsites are too small, retired and full-timer since Dec. 2020. Part of RV family since 1963.

Re: Ignition power/wire for fass fuel system

Reply #2 –
Sorry I went outside to check how I wired it and put the answer in the wrong post.

I ran the wires up to the back of under the bed with all the other electrical and put a relay there and got
the keyed power from at the back of the coach where the start button is as that is key power. I also removed
the wiring and the switches from the Winns system.
Peter and Frieda Morin
1999 36ft. U320 Foretravel
Build # 5436
1998 Suzuki Sidekick Sport