Skip to main content ↑ ↓
Topic: Replacing water pump / tank fill breaker/fuse? (Read 201 times) previous topic - next topic

Replacing water pump / tank fill breaker/fuse?

While wiring up the new water fill valve I managed to pop (break?) the DC 12 volt 15 amp breaker/fuse under the large grey cover in basement drivers side. I verified the problem with a temporary jumper (30 second test).  Photo atchd

How do I replace that breaker? Does entire copper bar at left side have to come off?  Safe guards if that is the case?

Is this part available at hardwware stores or auto parts store?

Will do a search of forum a bit latter - have another task to complete first.

Dan - Full timing since 2009
2003 U320 40' Tag 2 slide

Re: Replacing water pump / tank fill breaker/fuse?

Reply #1 –
To replace the breaker you will need to remove the copper bar and yes they are ready available.
They should reset themselves when they cool down. There are some that have a little button on
them to reset them.
Peter and Frieda Morin
1999 36ft. U320 Foretravel
Build # 5436
1998 Suzuki Sidekick Sport

Re: Replacing water pump / tank fill breaker/fuse?

Reply #2 –
Quote from: oldguy –
To replace the breaker you will need to remove the copper bar and yes they are ready available.
They should reset themselves when they cool down. There are some that have a little button on
them to reset them.


Thanks!!  I was aware some had reset buttons but was only looking on the face. On the left side hidden by the copper bar there was a reset button and we are operational again!
Dan - Full timing since 2009
2003 U320 40' Tag 2 slide