Skip to main content
Topic: Power Tech wiring help (Read 164 times) previous topic - next topic

Power Tech wiring help

Anyone have a 94 Grand Villa with a 10K power Tech generator?

I need to see if I can get a picture of the breaker wiring so that I can put mine back together. I have the breaker wiring correct as i was careful to take photos but in the bottom of the box there is a small white connector with many smaller pins and several wires going to it that I missed in my photos and I don't know which wire goes to which pin. there were about three that came loose from that white multi pin device and I really need to get it back together, its about the size of an automotive relay but just a lot of small flat pins sticking up they are about an 1/8th to a 1/16th  of an inch wide and stand about 1/2 inch tall they are located in the bottom of the breaker box just to right of the bottom of the breaker. i'm happy to pay for your time for the help if need be. or if someone had the schematics for that and I could get a copy. that would be awesome as well.
The Pedigo's David & Natalie

Re: Power Tech wiring help

Reply #1
David
can you post a photo of the device you are asking about? I'll see what photos of my rebuild that I can find.

If you are referring to the voltage regulator, this has to be connected exactly right or it will be a very expensive learning curve.....

It sounds like you may be referring to the external control wiring harness, I'm still looking for a photo of that plug, not sure if I have one that is clear enough to help.
Justin & Cathy Byrd
1995 U280 "Old Faithful"
36' Build #4673
C8.3 Cummins
Allison MD3060R 6 speed - retarder
Powertech 10KW  4cyl Kubota