Re: New sureflo water pump cycling
Reply #7 –
Yes it was probably the overflow, we always try to not go over the 7/8 full.
The wall of the tank is visible in the wet bay and I timed the fill and made a mark every 10 minutes of fill time. I can look and I will leave it for twenty minutes and know just how full it will be.
If you take the nut off the handle of the fill valve You can remove the floor panel and check the alignment of the valve for a true off position.
You could shut everything off at the manablock and see if the pump stops cycling, if it does it's a limbo g issue, open one supply valve at a time (closing it before you open the next one) and see if it's a dedicated line issue,
Check the over pressure valve (TPR) on the water heater to see if it's weeping wet - do not release this valve.